AutoPot 9mm Inline Tap
This inline tap is perfect for easy control over the water supply in your AutoPot system. Use it to open and close your nutrient supply, or for easy maintenance.
Grow with the flow
The tap opens and closes the nutrient supply line. Control the water supply to one individual pipe, or attach the tap near your reservoir to adjust your entire system at the twist of a valve.
Easy line maintenance
AutoPot recommends that you drain your lines every 2 weeks to keep the system clean and prevent sediment buildup.
A tap is by far the easiest way of doing this! Open the tap at the end of each line and allow 1-2L of water to run out. When you’re finished, check for blockages and shut the tap off again.
It’s also recommended that you dismantle and clean your system thoroughly every so often.
Compatible with AutoPot 9mm equipment
This inline tap fits the original 9mm AutoPot tubing. If you’re using the newer 16mm tubing, you’ll need to use the 16mm Inline Tap. Or you can use an adaptor like the 16 - 9mm Cross Connector to link your two sizes together.
How to use AutoPot 9mm Inline Tap?
If using in the middle of your automatic watering system, attach both ends of the tap into a length of 9mm tubing.
If using on the end of a line to clean or drain the system, simply connect to one end.
Ensure that the tap is fully inserted and that no air or water can escape. Then, twist the red valve to open and close the nutrient supply line.
Why choose AutoPot 9mm Inline Tap?
Use to control individual nutrient supply lines;
Instantly shuts off or turns on water supply from your reservoir;
Useful when cleaning or draining your AutoPot system;
Compatible with 9mm tubing and equipment;
Bright colour for easy visibility.
AutoPot 9mm In-Line Tap
Product Dimensions: 30 x 55 x 10mm